One of the harder parts of this project is figuring out how to easily connect.
Diy pull up bar.
Making a diy pull up bar in 5 simple steps step 1.
In general i recommend.
Supplies needed one 2 4 or other scrap wood one 1 inch x 36 inch galvanized pipe two 1 inch galvanized cap fittings tennis grip tape optional wood screws 1 1 2 inch spade drill bit power drill.
The buckets will fit snugly inside the holes when they are the right size.
Thread one of the flanges onto the opposite.
Using the 48 inch piece of galvanized steel pipe and working with one set of the piece finished in the step above.
Set buckets inside the holes to test their size.
The only labor intensive part of this project is digging the holes.
Make each hole big enough to hold a 5 us gal 19 l plastic bucket.
Thread the pipe into one end of the galvanized 90 degree elbow.
Space the holes 4 ft 1 2 m apart or the length of the steel bar you plan on using for your pull up bar.